C7.1 Industrial Engine Temperature Sensor (Cooled Exhaust Gas)

Temperature Sensor (Cooled Exhaust Gas) - Remove and Install

C7.1 Industrial Engine [KENR9105]

1.1. Removal Procedure

2.1. Installation Procedure

Removal Procedure

Show/hide table

Disconnect plastic tube assembly (1) for the crankcase breather from valve mechanism cover.
Slide the locking tab into the unlocked position. Disconnect engine wiring harness assembly (5) from wiring harness assembly (6). Slide connection for wiring harness assembly (6) from bracket (7).
Cut cable straps (2).
Remove temperature sensor (4) from NOx Reduction System (NRS) inlet air control (3).

Show/hide table

Table 1
Required Tools
Tool	Part Number	Part Description	Qty
A	-	Bostik Pure Nickel Anti-Seize Compound	1

Show/hide table

NOTICE

Ensure that wiring harness are correctly routed and the cable straps are not over tightened. Over tightening of the cable straps will damage the wiring harness convoluting.

Ensure that all components are clean and free from wear and damage. If necessary, replace any components that are worn or damaged.
Show/hide table

Illustration 2 g02168393
Lightly lubricate the thread of temperature sensor (4) with Tooling (A). Install temperature sensor (4) to NRS inlet air control (3).
Tighten temperature sensors (4) to a torque of 24 N·m (212 lb in).
Slide connection for wiring harness assembly (6) onto bracket (7). Connect engine wiring harness assembly (5) to wiring harness assembly (6). Slide the locking tab into the locked position.
Install new cable straps (2) to harness assembly (6).
Note: Ensure that cable straps meet the Original Equipment Manufactures (OEM) specification.
Connect plastic tube assembly (1) for crankcase breather to valve mechanism cover.